You will be redirected to XBee Explorer Regulated in a few seconds.

Home :: Wireless :: ZigBee & 802.15.4 :: XBee Explorer Regulated

XBee Explorer Regulated

XBee Explorer Regulated
 
(1 reviews)  

Description: The XBee Explorer Regulated takes care of the 3.3V regulation, signal conditioning, and basic activity indicators (Power, RSSI and DIN/DOUT activity LEDs). It translates the 5V serial signals to 3.3V so that you can connect a 5V (down to 3.3V) system to any XBee module. The board was conveniently designed to mate directly with Arduino Pro boards for wireless bootloading and USB based configuration.

This unit works with all XBee modules including the Series 1 and 2, standard and Pro versions. Plug an XBee into this breakout and you will have direct access to the serial and programming pins on the XBee unit and will be able to power the XBee with 5V.

This board comes fully populated with 3.3V regulator (16V max input), XBee socket, four status LEDs, and level shifting. In the latest revision the diode level shifter is replaced with a more robust MOSFET level shifter. This board does not include and XBee module. XBee modules sold below.

Note: A pull-up on DIN is required for this board to work properly. Thankfully, Series 1 and Series 2 XBee modules have their internal pull-up enabled by default. You will need to manually enable the pull-up on the 900MHz series.

Documents:

Replaces: WRL-09132

SKU WRL-11373
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 0.37 oz
 
Price: $9.95
Qty Out of stock
: *
: *
: *
 
 
 
Breakout Board for SC16IS750 I2C/SPI-to-UART IC
 
LED - Super Bright Yellow (100 pack)
 
Magnet Wire Kit
$14.95
 
$14.95
 
$9.95
 
 
 
SOIC-48 to DIP-48 SMT Adapter (1.27 mm pitch, 300 mil body)
 
TSSOP-14-Exp-Pad (0.65 mm pitch) Stainless Steel Stencil
 
0.1" (2.54mm) Crimp Connector Housing: 1x5-Pin 10-Pack
$6.59
 
$10.99
 
$0.59
 
 
 
Shaft Coupler - 3/8" to 3/8"
 
Precision Disc Wheel - 5" (Black)
 
Shaft - D-Shaft (Stainless; 1/4"D x 1.75"L)
$4.99
 
$6.99
 
$1.39
Average customer rating:
 
(1 reviews)  



1 Most useful customer reviews (see all reviews):
Matthew Vincie
Aug 22, 2013
In trying to use the XBee Explorer with the Ardupilot Mega (APM) 2.5, I found that the telemetry port on APM produced the 0-5V serial signal; but when connected to the Xbee Explorer, the APM could not sink enough current to vary the signal reaching the modem.

Advantages: Simple design and low cost.

Disadvantages: Won't work with the Ardupilot 2.5
Loading...Was the above review useful to you? Yes (0) / No (0)

Gift certificates