You will be redirected to USB Host Shield in a few seconds.

Home :: Arduino :: Shields :: USB Host Shield

USB Host Shield

USB Host Shield
 
(0 reviews)  

Description:  This new version corrects the pin out for the GPX and RESET pins. The USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device – thumbdrives, digital cameras, bluetooth dongles, and much more!

A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino's hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.

The Host Shield takes its power from the 'Vin' pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

Documents:

Replaces: DEV-09628

SKU DEV-09947
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 1.06 oz
 
Price: $24.95
Qty Out of stock
: *
: *
: *
 
 
 
DIP Sockets Solder Tail - 28-Pin 0.3"
 
Thumb Joystick
 
Piezo Vibration Sensor - Large with Mass
$0.95
 
$3.95
 
$2.95
 
 
 
Jumper Wire - JST 4-Pin
 
Miniature Solar Cell - BPW34
 
Serial Enabled 20x4 LCD - Black on Green 5V
$1.50
 
$1.50
 
$29.95
 
 
 
5-Way Selector Switch
 
Jumper Wires Premium 6" M/M - 20 AWG (10 Pack)
 
TSOP-32(I) to DIP-32 SMT Adapter (0.5 mm pitch, 11.8 mm body)
$2.95
 
$4.95
 
$6.99
There have been no reviews


Gift certificates