You will be redirected to PowerSwitch Tail II in a few seconds.

Home :: Components :: General :: PowerSwitch Tail II

PowerSwitch Tail II

PowerSwitch Tail II
(0 reviews)  

Description: Want to control a standard wall outlet device with your micro controller, but don't want to mess with the high voltage wiring? This might just be the right device for you!

The PowerSwitch Tail II is designed to allow you to safely control an outlet device without exposing any 120VAC voltages. You can plug in any standard 120VAC 3-prong outlet to be controlled by most any microcontroller. This will work great with Arduino! The PowerSwitch Tail II improves on the original PowerSwitch Tail by allowing you to switch a bigger load (now up to 15A) with a wider range of control signals (3-12VDC).


  • Connect to Arduino, PIC, Stamp, or other MCU with driver transistor or ULN2803
  • LED indicator shows status of control signal
  • Connect output receptacle to a single powered device or to a power strip to control multiple loads.
  • Switches up to 15A (resistive loads) with a 3-12VDC, 3-30mA control signal.


SKU COM-10747
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 19.34 oz
Price: $28.95
Qty Out of stock
: *
: *
: *
Jumper Wire - 0.1", 3-pin, 4"
Ribbon Crimp Connector - 10-pin (2x5, Female)
MMA7341LC 3-Axis Accelerometer ±3/11g with Voltage Regulator
QFN-20 (0.5 mm pitch, 4 x 4 mm body) Stainless Steel Stencil
QFN-28 to DIP-32 SMT Adapter (0.4 mm pitch, 4 x 4 mm body, 2.4 x 2.4 mm pad)
Set Screw Hub - 1/8" Bore
HS-485HB servo
Flanged Standoff A - 8mm (2 Pack)
SparkFun RFID Starter Kit
There have been no reviews

Gift certificates