You will be redirected to Monster Moto Shield in a few seconds.

Home :: Arduino :: Shields :: Monster Moto Shield

Monster Moto Shield

Monster Moto Shield
(0 reviews)  

Description: This is essentially a ramped up version of our Ardumoto motor driver shield. For this monster shield we've replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. We've also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! The VIN and motor out are pitched for our 5mm screw terminals (not included), making it easy to connect larger gauge wires.

Note: When using this board in extreme high-demand applications it may be necessary to improve thermal performance with a heat-sink or fan and to solder the wires directly to the board instead of using a screw terminal (in addition to the myriad other complications present in a high-current system) However, when using the board at currents up to 6A the chips will barely become noticeably warm.


  • Voltage max: 16V
  • Maximum current rating: 30 A
  • Practical Continuous Current: 14 A
  • Current sensing available to Arduino analog pin
  • MOSFET on-resistance: 19 mΩ (per leg)
  • Maximum PWM frequency: 20 kHz
  • Thermal Shutdown
  • Undervoltage and Overvoltage shutdown


SKU DEV-10182
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 1.48 oz
Price: $79.95
Qty Out of stock
: *
: *
: *
Ceramic Resonator 8MHz
LED - Ultraviolet
50 Channel GS406 Helical GPS Receiver - SMD Connector
LinkM - USB to I2C
Connector 1.0mm Horizontal - 6 pin
VoiceBox Shield
XBee 1mW Trace Antenna - Series 1 (802.15.4)
Raspberry Pi Display Module - 4.3" Touchscreen LCD
GPS Breakout
There have been no reviews

Gift certificates