You will be redirected to Luxeon Rebel LED Single Driver in a few seconds.

Home :: Components :: LEDs :: SMD :: Luxeon Rebel LED Single Driver

Luxeon Rebel LED Single Driver

Luxeon Rebel LED Single Driver
 
(0 reviews)  

Description: Here is a driver board based on the ZXLD1360. It allows you to control three LEDs with the same driver. If you don't need to discretely control all three, this is the board for you. This is made to mate with the Luxeon Rebel breakout boards.

Each LED driven to ~650mA with adjust pins open, off when adjust pins grounded.

Note: PWM control must be with an open pin (PWM high) or ground (PWM low). Do not pull the adjust pins high unless you want to drive the LEDs at greater than 650mA. The adjust pin on a ZXLD1360 driver chip causes the current to be off when it's held low, and on when it's open (or hi Z). Driving the pin at a DC level will cause the current regulation to be something other than the 650mA that the open adjust pin will regulate to, possibly much higher. Tread lightly if you don't know what you're doing.

Documents:

SKU COM-09748
Stock Out of Stock
Ships No Date Available.
Weight 0.63 oz
 
Price: $23.95
Qty Out of stock
: *
: *
: *
 
 
 
littleBits Korg Synth Kit
 
Micro Gripper Kit A - Straight Mount
 
Spectrum Shield
$172.22
 
$5.95
 
$29.95
 
 
 
Connector Plug 2 Position 2.5mm
 
LilyPad Sewable Electronics Kit - Special Edition
 
SOIC-24 (1.27 mm pitch, 300 mil body) Stainless Steel Stencil
$1.49
 
$99.95
 
$10.99
 
 
 
Reed Switch
 
LED - Super Bright Red (100 pack)
 
Ribbon Connector - GP-2106
$1.50
 
$19.95
 
$1.50
There have been no reviews


Gift certificates