You will be redirected to LiPower Shield in a few seconds.

Home :: Arduino :: Shields :: LiPower Shield

LiPower Shield

LiPower Shield
 
(0 reviews)  

Description: Is there anything an Arduino can't do? Well, for one, most of them can't be powered directly from a 3.7V LiPo battery; much less charge and monitor that battery. The LiPower Shield takes care of this by combining the functionality of two of our favorite battery power boards: the Power Cell and the Fuel Gauge.

The LiPower Shield allows you to connect a 3.7V single cell Lithium polymer battery which it will boost up to 5V and connect to the Arduino board's 5V pin. The on-board MAX17043G+U IC is connected to the I2C lines (A4 and A5) so that your project can monitor it's own power supply. The configurable alert interrupt pin on the MAX17043G+U IC is broken out to D3 which will activate when the LiPo gets to 32% or lower.

The charging circuit is configured to charge the LiPo at 100mA but by adding a resistor to the supplied through-holes you can boost this to 500mA. There is a mini-USB port on the shield which allows you to charge the battery from a USB power source or you can supply a separate regulated 5V source on the "charge" header.

Note: We've decided to leave the power indicator LED (LED1) and its current limiting resistor (R3) off this board, as they were producing a significant drain on the battery. Please be aware that your board will have a few, shiny, unpopulated pads.

Note: There is a known hardware bug that will allow the LiPo to discharge below the point where the charging circuit will revive it. Thanks to the on-board fuel gauge, however, some clever programming could keep your project from draining the battery as it gets too low.

Documents:

SKU DEV-10711
Stock Out of Stock
Ships No Date Available.
Weight 0.99 oz
 
Price: $29.95
Qty Out of stock
: *
: *
: *
 
 
 
Making Android Accessories with IOIO
 
Resistor 1k Ohm 1/4 Watt
 
SSOP-24 to DIP-24 SMT Adapter (0.65 mm pitch)
$7.95
 
$0.19
 
$4.99
 
 
 
TSOP-54 (II) to DIP-54 SMT Adapter (0.8 mm pitch, 10.16 mm body)
 
QFN-28 to DIP-32 SMT Adapter (0.5 mm pitch, 4 x 5 mm body, 2.5 x 3.5 mm pad)
 
Multi-Chassis - 4WD Kit (ATV)
$8.99
 
$8.99
 
$44.95
 
 
 
Clamping Hub - 3/16" Bore
 
Shaft Coupler - 5/16" to 5/16"
 
Tube - Aluminum (3/8"OD x 6.0"L x 0.30"ID)
$7.99
 
$4.99
 
$2.19
There have been no reviews


Gift certificates