You will be redirected to Battery Holder - 4xAA to Barrel Jack Connector in a few seconds.

Home :: Prototyping :: Batteries :: Battery Holder - 4xAA to Barrel Jack Connector

Battery Holder - 4xAA to Barrel Jack Connector

Battery Holder - 4xAA to Barrel Jack Connector
 
(0 reviews)  

Description: This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5×2.1mm, center positive barrel jack connector.

The connector mates with the barrel jack on the Arduino (among a number of other products) allowing you to easily make your project battery powered.

Note: the average voltage regulator has about 1V of dropout (but can vary greatly). This pack, with normal alkaline batteries, will output ~5.5V causing a normal 5V board to run at around 4 to 4.5V. This depends a lot of what board and processor you are using with the battery pack. Please consult yer datasheet.

SKU PRT-09835
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 1.53 oz
 
Price: $2.49
Qty Out of stock
: *
: *
: *
 
 
 
Magnetic Card Reader
 
Snap Assortment - 30 pack (male and female)
 
Adapter board for Microchip ICD and ICD2
$59.95
 
$2.95
 
$4.95
 
 
 
QFN-28 (0.5 mm pitch, 5 x 5 mm body, 3.1 x 3.1 mm pad) Stainless Steel Stencil
 
Header - 6-pin Female (PTH, 0.1")
 
SparkFun OpenLog
$10.99
 
$0.50
 
$14.95
 
 
 
SparkFun Inventor's Kit for Arduino 101 - Special Edition
 
Make: Wearable Electronics
 
Pioneer IoT Add-On Shield
$139.95
 
$34.95
 
$19.95
There have been no reviews


Gift certificates