You will be redirected to ATmega328 with Arduino Optiboot (Uno) in a few seconds.

Home :: Arduino :: ATmega328 with Arduino Optiboot (Uno)

ATmega328 with Arduino Optiboot (Uno)

ATmega328 with Arduino Optiboot (Uno)
 
(0 reviews)  

Description: The name says it all on this one. An ATmega328 in DIP package, pre-loaded with the Arduino Optiboot (Uno 16MHz) Bootloader. This will allow you to use Arduino code in your custom embedded project without having to use an actual Arduino board.

To get this chip working with Arduino IDE, you will need an external 16MHz crystal or resonator, a 5V supply, and a serial connection. If you are not comfortable doing this, we recommend purchasing the Arduino Uno board that has all of these built into the board.

Atmel's ATMega328 8-Bit Processor in 28 pin DIP package. It's like the ATmega168, with double the flash space. 32K of program space. 23 I/O lines, 6 of which are channels for the 10-bit ADC. Runs up to 20MHz with external crystal. Package can be  programmed in circuit. 1.8V to 5V operating voltage!

Note: This contains the bootloader used on the Arduino Uno, with small modifications to work more reliably with different serial connection options (mainly the FTDI). Check the link below for more information.

Documents:

Replaces:  DEV-09217

SKU DEV-10524
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 0.21 oz
 
Price: $5.50
Qty Out of stock
: *
: *
: *
 
 
 
Breakout Board for L298N Full-Bridge Motor Driver
 
LilyPad LED Blue (5pcs)
 
EL Wire - Green 3m
$2.95
 
$4.95
 
$9.95
 
 
 
Analog Panel Meter - 0 to 5 VDC
 
Resistor 10K Ohm 1/6th Watt PTH - 20 pack
 
Reed Switch - Insulated
$4.95
 
$0.95
 
$1.95
 
 
 
Diffused LED - RGB 10mm
 
Barcode Reader/Scanner Module - CCD Camera - USB Interface
 
SOT-223-5 to DIP-6 SMT Adapter (1.5 mm pitch)
$0.95
 
$67.95
 
$2.99
There have been no reviews


Gift certificates