You will be redirected to Arduino Project Enclosure in a few seconds.

Home :: Prototyping :: Enclosures :: Arduino Project Enclosure

Arduino Project Enclosure

Arduino Project Enclosure
(0 reviews)  

Description: The Arduino enclosure allows you to easily enclose your Arduino main board, Arduino Mega, or some of the other board that fits the Arduino foot print. It simply presses shut, so you don’t have to worry about screws or fasteners.

It has room internally for an Arduino and a shield. It even has a removable tab mated for use with an Ethernet shield. It also has a snap-in compartment in the back for accessing switches or connections or battery access.

Note: Some older Arduino boards have a slightly smaller hole near the rear the ICSP connector. To make the case work with these boards simply drill out the hole to 1/8″ and you will be fine. Also, with the newer Ethernet Shields, you will need to remove one of the pegs to get everything to fit correctly.

Note: This does not work with the FEZ Domino.

Dimensions: 87x64x28mm

SKU PRT-10088
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 4.99 oz
Price: $11.95
Qty Out of stock
: *
: *
: *
Hall-Effect Current Sensor Breakout - ACS712
Dual/Quad Power Amplifier - STA540
Battery Holder 2xAA with Cover and Switch - JST Connector
WiFly GSX 802.11b/g Serial Module - Roving Networks
Standoffs Plastic 3/8" (10 pack)
Screw Terminals 2.54mm Pitch (2-Pin)
SSOP to DIP Adapter 28-Pin
Raspberry Pi - GPIO Shrouded Header (2x13)
QFN-40 to DIP-40 SMT Adapter (0.5 mm pitch, 6 x 6 mm body)
There have been no reviews

Gift certificates