You will be redirected to USB LiPoly Charger - Single Cell in a few seconds.

Home :: Prototyping :: Batteries :: USB LiPoly Charger - Single Cell

USB LiPoly Charger - Single Cell

USB LiPoly Charger - Single Cell
(0 reviews)  

If you need to charge LiPo batteries, this simple charger will do just that, and do it fast! The USB LiPo Charger is a basic charging circuit that allows you to charge 3.7V LiPo cells at a rate of 500mA or 100mA. It is designed to charge single-cell Li-Ion or Li-Polymer batteries.

The board incorporates a charging circuit, status LED, selectable solder jumper for 500mA or 100mA charging current, external LED footprint, USB input, two pre-installed JST connectors for SYS OUT and BATT IN, and (back by popular demand) a barrel jack connector.

There is also a ‘SYS OUT’ with a pre-installed JST connector which allows you to connect the charging circuit directly to your project so you don’t need to disconnect the charger each time you want to use it.


SKU PRT-12711
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 1.02 oz
Price: $14.95
Qty Out of stock
: *
: *
: *
RS232 Shifter SMD
Nike+iPod Serial to USB Adapter
SoftPot Membrane Potentiometer - 200mm
Diffused LED - Yellow 10mm
PICAXE 08M2 Microcontroller (8 pin)
Small Heatsink
XBee 1mW Trace Antenna - Series 1 (802.15.4)
Resistor 22k Ohm 1/4 Watt
QFN-32 to DIP-36 SMT Adapter (0.5 mm pitch, 5 x 6 mm body, 2.48 x 3.4 mm pad)
There have been no reviews

Gift certificates