You will be redirected to SparkFun Humidity and Temperature Sensor Breakout - Si7021 in a few seconds.

Home :: Sensors :: Weather :: SparkFun Humidity and Temperature Sensor Breakout - Si7021

SparkFun Humidity and Temperature Sensor Breakout - Si7021

SparkFun Humidity and Temperature Sensor Breakout - Si7021
 
(0 reviews)  

The Si7021 is a low-cost, easy-to-use, highly accurate, digital humidity and temperature sensor. This sensor is ideal for environmental sensing and data logging and perfect for build a weather stations or humidor control system. All you need are two lines for I2C communication, and you’ll have relative humidity readings and very accurate temperature readings as a bonus!

There are only four pins that need to be hooked up in order to start using this sensor in a project. One for VCC, one for GND, and two data lines for I2C communication. This breakout board has built-in 4.7KΩ pullup resistors for I2C communications. If you’re hooking up multiple I2C devices on the same bus, you may want to disable these resistors.

Note: Full drops of water can damage the sensor. We recommend wrapping the board in Teflon/irrigation tape for extreme conditions where water droplets may find their way onto the sensor.

Dimensions: 0.6" x 0.6"

Documents:

SKU SEN-13763
Stock Out of Stock
Ships No Date Available.
Weight 0.09 oz
 
Price: $11.95
Qty Out of stock
: *
: *
: *
 
 
 
SparkFun Line Follower Array
 
Teensy 3.5
 
MOTORplate
$29.95
 
$24.95
 
$33.95
 
 
 
Reverse Polarized SMA Connector
 
DIP Sockets Solder Tail - 8-Pin
 
ProtoBoard - Square 2"
$1.95
 
$0.50
 
$2.95
 
 
 
RFID USB Reader
 
EL Wire - Blue-Green 3m
 
EL Escudo Dos
$24.95
 
$9.95
 
$24.95
There have been no reviews


Gift certificates