You will be redirected to SparkFun Breadboard Power Supply Stick - 3.3V/1.8V in a few seconds.

Home :: Prototyping :: General :: SparkFun Breadboard Power Supply Stick - 3.3V/1.8V

SparkFun Breadboard Power Supply Stick - 3.3V/1.8V

SparkFun Breadboard Power Supply Stick - 3.3V/1.8V
 
(0 reviews)  

This is a very simple board that takes a 4-9V input voltage and outputs a selectable 1.8V or 3.3V regulated voltage. All headers are 0.1" pitch for simple insertion into a breadboard.

Input power can be supplied to either the DC barrel jack or the two pin header labeled + and -. Output power is supplied to the pins labeled GND and VCC. Board has both an On/Off switch and a voltage select switch (3.3V/1.8V).

The two sets of four GND and VCC pins are spaced such that when connected to our Basic Breadboard both power busses will be powered.

Note: Headers are not supplied. You will need to supply your own headers to connect this board to a breadboard. Check below for some breakaway header strips.

Dimensions: 2.15x0.65"

Features:

  • 4-9V input voltage via barrel jack or 2-pin header
  • 3.3V or 1.8V regulated output voltage
  • 800mA Operating Current
  • ON/OFF switch
  • Output voltage select switch
  • Power status LED
  • PTC fuse protected power
  • 5.5x2.1mm center positive barrel jack

Documents:

SKU PRT-13157
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 0.51 oz
 
Price: $14.95
Qty Out of stock
: *
: *
: *
 
 
 
Circuit Scribe Lite Kit
 
SparkFun Breadboard Power Supply Stick - 5V/3.3V
 
SparkFun Photon Battery Shield
$24.95
 
$14.95
 
$12.95
 
 
 
SparkFun Load Sensor Combinator (Ver. 1.1)
 
SparkFun RedBoard - Programmed with Arduino
 
Polarized Connectors - Header (6-Pin)
$1.95
 
$19.95
 
$0.45
 
 
 
5V DC to DC Step Up - 2xAA
 
Motor Driver 15A IRF7862PBF
 
Serial Enabled 16x2 LCD - Black on Green 5V
$10.95
 
$39.95
 
$24.95
There have been no reviews


Gift certificates