You will be redirected to Relay Shield in a few seconds.

Home :: Arduino :: Shields :: Relay Shield

Relay Shield

Relay Shield
 
(0 reviews)  

Description: This Relay Shield from Evil Mad Scientist is a simple Arduino add-on that gives your Arduino the ability to control a single electromechanical relay for switching loads of up to 24VDC or 40VAC. Each Relay Shield comes equipped with a single pole - double throw (SPDT) sealed relay which can handle a current load of up to 5A. This means that when current is applied to the coil it throws a simple changeover switch, terminating the connection from the NC (Normally Closed) contact to ground and closing the NO (Normally Open) contact. Use them to switch high voltage/high current devices. As this is a shield, it is powered straight from the 5V power supplied by your Arduino, simply slide it into your Arduino or shield-compatible board (like the RedBoard) and you will be good to go!

The relay shield is controlled through pin Digital 4 on your Arduino via a transistor labeled "Q1". When output Digital 4 on your Arduino is low, the relay shield will connect the NC pin to the "Common" pin of the screw terminal. When output Digital 4 goes high, the “Coil On?” LED will light up and the relay shield will instead connect the NO pin to the "Common" pin of the screw terminal.

The Relay Shield is sold as an easy-to-assemble kit and includes everything listed below with clear assembly instructions listed in the documents section.

Includes:

  • 1x Relay Shield PCB
  • 1x GSLA SPDT 5A Relay
  • 1x Red LED, 3mm
  • 1x 100uF 10V Capacitor
  • 1x 0.1uF 25V Capacitor
  • 1x 2N4401 Transistor
  • 1x Screw Terminal, 3-pos
  • 1x Arduino Header Set
  • 2x 1000 ohm 1/4W Resistor
  • 2x 1N5817 Diode

Documents:

SKU DEV-12093
Stock 1 In Stock
Ships Today
Weight 2.19 oz
 
Price: $11.95
Qty
Add to wish list
: *
: *
: *
 
 
 
Ceramic Resonator 8MHz
 
Momentary Reset Switch SMD
 
Keypad - 12 Button
$0.95
 
$0.95
 
$3.95
 
 
 
1500 mAh Alkaline Battery - AA
 
Breakout Board for SC16IS750 I2C/SPI-to-UART IC
 
EL Wire - Orange 3m
$0.50
 
$14.95
 
$9.95
 
 
 
Timer, OpAmp & Optoelectronic Circuits & Projects
 
MintyBoost 3.0 Kit
 
Ball Bearing - Flanged (1/4" Bore, 1/2" OD)
$12.95
 
$19.95
 
$1.69
There have been no reviews


Gift certificates