You will be redirected to RS485 Shield V2 - Raspberry Pi in a few seconds.

Home :: Development Tools :: Raspberry Pi :: RS485 Shield V2 - Raspberry Pi

RS485 Shield V2 - Raspberry Pi

RS485 Shield V2 - Raspberry Pi
 
(0 reviews)  

Our friends over at LinkSprite have made this nifty little RS485 Shield V2 for the Raspberry Pi, now you will be able to have a communication port for your field bus directly connected to your RPi! Even though the RS485 is sometimes thought as an “archaic” protocol, it will allow up to 32 devices to communicate through the same data line over a cable length of up to 4,000ft with a maximum data rate of 10Mbit/s. Those aren’t bad numbers!

This shield comes pre-assembled so all you will need to do is just snap it right onto your Raspberry Pi and get programming. The RS485 Shield V2 is compatible with Raspberry Pi B, B+ and Raspberry Pi 2.

Note: The shield has an unpopulated footprint for a DB9 connector. Check below if you need to add the connector. Otherwise you can use the screw terminals.

Documents:

SKU DEV-13000
Stock Out of Stock
Ships No Date Available.
Weight 4.03 oz
 
Price: $13.95
Qty Out of stock
: *
: *
: *
 
 
 
SOIC-16 (1.27 mm pitch, 300 mil body) Stainless Steel Stencil
 
LilyPad Temperature Sensor
 
P-Channel MOSFET 60V 27A
$10.99
 
$4.95
 
$0.95
 
 
 
Jumper Wire - 0.1", 3-pin, 4"
 
Quick Disconnect - Female 1/4" (bag of 50)
 
Robot Builder's Bonanza
$0.95
 
$3.95
 
$29.95
 
 
 
DSO Nano V3 - Pocket-Sized Digital Oscilloscope
 
DFN-10 to DIP-10 SMT Adapter (0.4 mm pitch, 2.0 x 2.0 mm body)
 
Servo - Hitec HS-425BB (Standard Size)
$99.95
 
$4.99
 
$12.95
There have been no reviews


Gift certificates