You will be redirected to Qwiic RFID ID-XXLA in a few seconds.

Home :: Sensors :: ID :: Qwiic RFID ID-XXLA


(0 reviews)  

The Qwiic RFID ID-XXLA is a simple board that pairs with and comes in a kit with, the ID-12LA and three RFID 125kHz cards to get you started integrating an I2C RFID solution into your project. Utilizing the onboard ATtiny84A, the Qwiic RFID takes the six byte ID tag of your 125kHz RFID card, attaches a time stamp to it, and puts it onto a stack that holds up to 20 unique RFID scans at a time. This information is easy to get at with some simple I2C commands and we’ve included some example code that shows you just how to do it using the broken out interrupt pin. The ID-12LA module has a scan range of about 5-6 inches and the board includes a buzzer and LED that indicates that a card has been scanned. We’ve included a jumper to disconnect the buzzer in case the noise is too grating (but does not disconnect the LED), a jumper for the I2C pull-up resistors, an interrupt jumper, and finally an address jumper.

The Qwiic RFID comes fully decked out in Qwiic connectors, no need to solder a thing, just plug it in and start scanning! Wait you haven’t heard of Qwiic?

Note:This board also pairs with the ID-3LA, and ID-20LA, RFID modules. The two antennae pins that should only be used with the smaller ID-3LA.

We do not plan to regularly produce SparkX products so get them while they’re hot!

Experimental Product: SparkX products are rapidly produced to bring you the most cutting edge technology as it becomes available. These products are tested but come with no guarantees. Live technical support is not available for SparkX products. Head on over to our forum for support or to ask a question.


SKU SPX-14867
Stock Out of Stock
Ships No Date Available.
Weight 0.51 oz
Price: $54.95
Qty Out of stock
: *
: *
: *
QFN-28 to DIP-32 SMT Adapter (0.65 mm pitch, 6 x 6 mm body, 4.1 x 4.1 mm pad)
Basic 8x2 Character LCD - Black on Green 3.3V
LED Light Bar - White (SMD)
Tube - Aluminum (1/2"OD x 6.0"L x 0.444"ID)
Standoff - Aluminum Threaded (6-32; 1/2")
Raspberry Pi Primary Display Cape - 3.5" Touchscreen
The SparkFun Guide to Processing
SparkFun Photon ProtoShield
Load Cell - 10kg, Straight Bar (TAL220)
There have been no reviews

Gift certificates