You will be redirected to Panel Mount Ethernet Extension Cable in a few seconds.

Home :: Cables :: Ethernet :: Panel Mount Ethernet Extension Cable

Panel Mount Ethernet Extension Cable

Panel Mount Ethernet Extension Cable
(0 reviews)  

This handy Ethernet extension cable will make it easy for you to enclose a device that has an Ethernet port. We think this would be most useful when putting a Beagle Bone, Raspberry Pi, Arduino Ethernet into a box.

The jack half has two mounting 'ears' with 4-40 screws installed, 1" inch / 25mm apart. The ears are flexible so the holes don't have to drilled very precisely. Can be used with box walls up to 0.25" wide. The screws can be put on from the back for 'reverse' mounting if the box thickness is a problem. Entire unit is 12" long (9" cabling between jack and RJ45 Ethernet connector).

  • Technical Details

    • Panel mount Ethernet 8P socket with Ethernet 8P plug at cable end. Straight-through extension
    • 24 AWG wires
    • 12" long / 31 cm from tip to tip
    • 9" / 23 cm cabling from jack to connector
    • Two 10mm 4-40 mounting screws, 25mm apart
    • Plastic "boot" at Ethernet end is 20.32mm tall x 33.14mm wide (21.00mm where it is smaller behind the mounting flange) x 28.32mm deep
Stock Out of Stock
Ships No Date Available.
Weight 7.00 oz
Price: $4.95
Quantity Price
250+ Items $3.95
Qty Out of stock
: *
: *
: *
Pogo Pins w/ Round Tip
Rotary Potentiometer - Linear (10k ohm)
WiFly GSX Breakout
Standoffs Plastic 3/8" (10 pack)
Breadboard Power Supply Stick 5V/3.3V
Non-Contact Infrared Thermometer
SparkFun Transceiver Breakout - MAX3232
SOIC to DIP Adapter 20-Pin
Adapter board for Microchip ICD and ICD2
There have been no reviews

Gift certificates