You will be redirected to MyoWare Power Shield in a few seconds.

Home :: Sensors :: Biometrics :: MyoWare Power Shield

MyoWare Power Shield

MyoWare Power Shield
 
(0 reviews)  

The MyoWare Power Shield is designed to take two standard CR2032 coin cell batteries to power the MyoWare Muscle Sensor. We have made this board in a way that the coin cell batteries are connected in parallel for extended capacity at a nominal 3.0V. Connecting the MyoWare Muscle Sensor to battery power allows for a cleaner signal while also eliminating the possibility of creating a dangerous current path to the power grid.

One thing to note is that due to the size of the batteries, the remote cable header on the MyoWare Miscle Sensor can’t be passed through. If you need access to these connections, this Power Shield will need to be stacked above the board(s) that need access.

The MyoWare Muscle Sensor, that this shield attaches to, is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts depending the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.

Documents:

SKU DEV-13684
Stock Out of Stock
Ships No Date Available.
Weight 0.67 oz
 
Price: $3.95
Qty Out of stock
: *
: *
: *
 
 
 
SSOP-48 to DIP-48 SMT Adapter (0.635 mm pitch)
 
Jumper Wires Premium 12" F/F Pack of 100
 
Solderless Headers - 10-pin Straight
$7.79
 
$34.95
 
$1.50
 
 
 
Thermal Printer Paper - 34'
 
Diffused LED - White 10mm
 
EggBot Deluxe Kit
$1.95
 
$0.50
 
$219.95
 
 
 
RQFP-208 to PGA-208 SMT Adapter (0.5 mm pitch, 28 x 28 mm body)
 
Servo - Hitec HS-425BB (Standard Size)
 
Clamping Hub - 4mm Bore
$17.99
 
$12.95
 
$7.99
There have been no reviews


Gift certificates