You will be redirected to MyoWare Cable Shield in a few seconds.

Home :: Sensors :: Biometrics :: MyoWare Cable Shield

MyoWare Cable Shield

MyoWare Cable Shield
 
(0 reviews)  

The MyoWare Muscle Sensor is now designed to be wearable allowing you to attach biomedical sensor pads directly to the board itself. However, there still may be cases where you want to mount the sensor pads away from the other hardware, this is where the MyoWare Cable Shield comes in. This shield provides a 3.5mm jack where you can attach a three electrode sensor cable allowing you to test and use the MyoWare Muscle Sensor without actually attaching it to your person.

The MyoWare Cable Shield is equipped with two rows of 3-pin plated through holes on each end of the board. This allows for standard 0.1" headers to be used to stack the shield with other MyoWare boards.

The MyoWare Muscle Sensor, that this shield attaches to, is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle; outputting 0-Vs Volts depending the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.

Documents:

SKU DEV-13687
Stock Out of Stock
Ships No Date Available.
Weight 0.67 oz
 
Price: $3.95
Qty Out of stock
: *
: *
: *
 
 
 
Quadruple Half-H Driver - L293DNE
 
Fairy Lights - Red (2.5m)
 
Fairy Lights - Orange (2.5m)
$3.50
 
$4.95
 
$4.95
 
 
 
Triple Axis Accelerometer - ADXL335
 
RFID Tag - Transparent MIFARE 1K (13.56 MHz)
 
Jumper Wire - 0.1", 5-pin, 4"
$9.95
 
$2.95
 
$0.95
 
 
 
LilyPad LED Micro - White (5pcs)
 
Super Bright LED - White 10mm
 
LogicBlocks Kit
$3.95
 
$1.50
 
$39.95
There have been no reviews


Gift certificates