You will be redirected to MiniGen - Pro Mini Signal Generator Shield in a few seconds.

Home :: Breakout Boards :: MiniGen - Pro Mini Signal Generator Shield

MiniGen - Pro Mini Signal Generator Shield

MiniGen - Pro Mini Signal Generator Shield
 
(0 reviews)  

This is the MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Thought the MinioGen is technically a shield it can, in fact, operate as a stand-alone board capable of the the same functionality as it would if it were placed on top of a Pro Mini.

The MiniGen offers two out put sources for you to utilize: a 2-pin 0.1" spaced header and a u.FL connector. The output is at a DC offset of Vcc/2, however neither the offset nor the amplitude can be varied. By default, the MiniGen ships configured with a 3.3V regulator enabled and should only be used with 3.3V signals (or 3.3V Pro Minis if you are using this as a shield) unless the jumper on the back is soldered over to bypass the regulator for 5V use.

Features:

  • 10-bit DAC for good accuracy
  • 2 frequency registers
  • 2 phase registers
  • SPI Interface Driven at 40MHz
  • Operating Voltage: 3.3V (5V when jumper is soldered)

Documents:

SKU BOB-11420
Stock On Backorder
Ships In 1 to 2 weeks.
Weight 0.35 oz
 
Price: $29.95
Qty Out of stock
: *
: *
: *
 
 
 
Mini Push Button Switch - Tall
 
Connector 1.0mm Horizontal - 2 pin
 
Micro Metal Gearmotor HP 50:1
$0.50
 
$0.95
 
$15.95
 
 
 
Pi Tin for the Raspberry Pi
 
Circular LED Bargraphs - Green
 
Resistor 4.7 Ohm 1/4 Watt
$9.95
 
$11.95
 
$0.19
 
 
 
QFN-14 to DIP-18 SMT Adapter (0.5 mm pitch, 3.5 x 3.5 mm body, 2 x 2 mm pad)
 
DFN-6 to DIP-10 SMT Adapter (0.5 mm pitch, 1.6 x 1.6 mm body)
 
QFN-16 (0.65 mm pitch, 4 x 4 mm body, 2.1 x 2.1 mm pad) Stainless Steel Stencil
$6.99
 
$4.49
 
$10.99
There have been no reviews


Gift certificates