You will be redirected to Hitec HS-5485HB Digital Servo in a few seconds.

Home :: Robotics :: Servos :: Hitec HS-5485HB Digital Servo

Hitec HS-5485HB Digital Servo

Hitec HS-5485HB Digital Servo
 
(0 reviews)  

The digital wave is now sweeping across the servo world and Hitec is leading the way. The HS-5485HB is Hitec’s second digital standard servo. Adding the digital component to the already great HS-485HB means that the 
HS-5485HB is even better. The torque numbers and speed are enhanced from the HS-485HB. The standing torque is nearly 5 times better and the precision has been increased. Being digital means the motor now receives the position signal 300 times per second rather than 30 times per second. This servo can also be programmed using our hand-held servo programmer. Need the servo to travel up to 180° no problem! Need to slow the servo down, no problem! You can do just about anything with Hitec digital servos in combination with the programmer.
 

Note: The HS-5485HB servo spline is slightly oversized and will be a very snug fit into broached servo accessories. After installed the first time, later assembly will be easier.

Control System: +Pulse Width Control 1500usec Neutral

Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.20sec/60° at no load
Operating Speed (6.0V): 0.17sec/60° at no load
Stall Torque (4.8V): 72oz/in. (5.2kg.cm)
Stall Torque (6.0V): 89 oz/in. (6.4kg.cm)

Operating Angle: 45 Deg. one side pulse traveling 400usec
Continuous Rotation Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8.8mA/idle and 400mA no load operating
Current Drain (6.0V): 9.1mA/idle and 500mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Indirect Drive 
Bearing Type: Ball Bearing
Gear Type: Karbonite Gear
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.57" x 0.78"x 1.49" (39.8 x 19.8 x 38mm)
Weight: 1.59oz. (45g)

SKU KRS-19460
Stock 4 In Stock
Ships Today
Weight 6.00 oz
 
Price: $24.99
Qty
Add to wish list
: *
: *
: *
 
 
 
Sylvia's Super Awesome Arduino Kit
 
TQFP-32 (0.8 mm pitch, 7 x 7 mm body) Stainless Steel Stencil
 
I2C EEPROM - 256kbit
$29.95
 
$10.99
 
$1.95
 
 
 
RFID USB Reader
 
3.3V step up/boost power supply (DC to DC)
 
Header - 6-pin Male (SMD, 0.1")
$24.95
 
$10.95
 
$0.50
 
 
 
Resistor 680 Ohm 1/4 Watt
 
Fingerprint Scanner - 5V TTL
 
QFN-28 to DIP-28 SMT Adapter (0.5 mm pitch, 5 x 5 mm body)
$0.19
 
$49.95
 
$6.99
There have been no reviews


Gift certificates