You will be redirected to Cubelets - Battery Charger in a few seconds.

Home :: Prototyping :: Batteries :: Cubelets - Battery Charger

Cubelets - Battery Charger

Cubelets - Battery Charger
 
(0 reviews)  

Cubelets are powered by 3.2V LiFePO4 batteries, which can’t be charged with just any charger. This is the battery charger that you’ll need for the Cubelets Battery Block. It can charge both batteries at once and includes adapters for both 120 to 240VAC home and 12VDC automotive use!

A built-in microprocessor automatically shuts down when batteries are fully charged. Charge 1 to 2 RCR123A from 1.5 hours to 3 hours. Built-in circuit provides thermal protection, overcharge protection, short-circuit protection, mechanical. and electrical protection against reversal polarity, and defective battery identification.

Note: Only use this unit to charge LiFePO4 batteries.

Dimensions: 2.5 x 4 x 1"

SKU TOL-11344
Stock Out of Stock
Ships No Date Available.
Weight 14.98 oz
 
Price: $14.95
Qty Out of stock
: *
: *
: *
 
 
 
Hex Key - Plas-T-Key T Handle (Straight End, 7/64")
 
Gas Sensor Breakout Board
 
Screw - Phillips Head (3/8", 2-56)
$4.95
 
$0.95
 
$0.15
 
 
 
48 Channel GP-2106 SiRF IV GPS Receiver
 
Screw - Flat Head (1.25", 4-40, 10 packs)
 
Resistor 100k Ohm - SMD (strip of 50)
$49.95
 
$1.50
 
$1.95
 
 
 
XBee 1mW Trace Antenna - Series 1 (802.15.4)
 
OpenSegment Serial Display - 20mm (Blue)
 
Timing Pulley - Shaft Mount (10T; 6mm Bore)
$22.95
 
$16.95
 
$4.99
There have been no reviews


Gift certificates